English; Important; Technical Data - IKEA TRADFRI Mode D'emploi

English

WIRELESS SIGNAL REPEATER FUNCTIONS
With TRÅDFRI signal repeater you can expand the
signal reach of your IKEA Home smart products.
Pairing: Add IKEA Home smart products to
your system. See instructions below.
ADDING STEERING DEVICE TO YOUR SIGNAL
REPEATER
When the Signal Repeater is sold together with
another IKEA Home smart product (in the same
package), they are already paired.
You cannot add IKEA Home smart products directly
to your signal repeater. A TRÅDFRI steering device is
needed to add them.
To add steering devices, just follow the steps below:
Make sure that your signal repeater is plugged in
and the main power is turned on.
1. Hold the steering device close to the signal
repeater you want to add (no more than 5 cm
away).
2. Press and hold the pairing button for at least 10
seconds , you can find the pairing button under
the rear cover.
3. A red light will shine steadily on the steering
device.
Then go to the product you want to steer and
then repeat the pairing.
On your IKEA Home smart products a white light
will begin to dim and flash one time to indicate that
it has been successfully paired.
FACTORY RESET YOUR DEVICE
For wireless signal repeater:
Push a pin into the pinhole on bottom of the signal
repeater for at least 5 seconds.
After reset the signal repeater you must pair your
steering device to the signal repeater and then
pair the steering device to your IKEA Home smart
product product again.

IMPORTANT!

• The Signal Repeater is for indoor use only and
can be used in temperatures ranging from 0ºC to
40 ºC (32ºF to 104 ºF).
• Do not leave the wireless Signal Repeater in
direct sunlight or near any heat source, as it may
overheat.
• The range between the wireless Signal Repeater
and the receiver are measured in open air.
Different building materials and placement of the
units can affect the wireless connectivity range.
WARNING:
• The wall socket must be located near the
equipment and must be easily accessible.
• Only use in dry locations.
• Children should be supervised to ensure they do
not play with the product.
• If the device is damaged it shall be destroyed.
• Never use a damage or faulty USB cable for
charging, since this can damage the appliance
and harm your device.

TECHNICAL DATA

Type: E1746 wireless Signal Repeater
Input: 5.0V DC
Range: 10 m in open air
For indoor use only
Operating frequency: 2405-2480MHz
Output power: 3 dBm
4