Sinbo SSI 2863 Mode D'emploi page 11

Spray
1. The spray can be used in any position, either in dry or steam ironing, as long as the water
tank is filled with water.
2. Press the spray button for this function
NOTE: This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max"position and wait until the pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts each time.
Several pumping actions are needed to start this function.
Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before
operating the shot of steam control
Cleaning
1. Disconnect the appliance from the mains, before cleaning.
2. Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
Defects and repairs
Do not attempt to replace a defective mains lead. The appliance has to be returned to an
authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture need to
be burnt off allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230Volt, AC electrical outlet only. The temperature dial must
be set at the desired temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to "0" and add water .Allow the iron to
heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should
be in the horizontal position. Prime pump briefly. Allow a short pause between shots. Be sure
to fully depress the burst of steam button.
Spray mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section "how to fill the
water tank".
Iron is leaking
The variable steam dial must be set on " ",until the iron is hot . The temperature setting is too
low to produce steam. Shot of steam used too much, allow iron to re-heat.
- 10 -