ThermoTec AeroFlow Mode D'emploi page 11

Set the time
Language
+ -
Sensor probe Offset
D
Antifreeze
+
Install
D
Information
!
Factory Reset
To exit the menu, confirm with OK. The Status Display appears.
Back
Select the current weekday and confirm with OK.
Monday
Select day
Use the arrow buttons to set the current hour. Confirm with OK. After this, set the current minute and confirm with OK
Set the time
as well.
09:00
Use this menu to change the language of your FlexiSmart user interface.
Use the arrow buttons to select one of the available languages. Confirm with OK.
English
Language
This menu item allows temperature measurement correction.
In case the room temperature being measured by the built-in sensor of the
compensation value can be set.
If for instance the
compensation. Example:
+ 1.0
• Room temperature = 21°C
• Displayed temperature = 20°C
Sensor probe Offset
• Set +1 and confirm with OK.
If Program = "ON", the Antifreeze temperature will activate in-between the two directly successive time frames.
Example: Time frame 1: 6:00 a.m. to 7:00 a.m. = 22,0 ° C
Time frame 2: 8:00 a.m. to 9:00 a.m. = 23,0 ° C
In the time between time frame 1 and time frame 2 (7:01 a.m. to 7:59 a.m.), the Antifreeze protection temperature is retained.
Select a Antifreeze temperature between 0 ° C and 17 ° C. Confirm with OK. The Antifreeze temperature can be
changed manually at any time in the Temperature-overview display and is retained temporarily until the beginning
1 °C
of the next time frame. After the preset end time of the next time frame, the Antifreeze temperature set in this
Antifreeze
menu is activated again (and can be changed manually again).
Note:
If "Smart Start" is activated, the AeroFlow® radiator will start to heat before the next time frame starts.
If "Smart Start" is deactivated, the Antifreeze temperature is retained until the set start time.
Use this menu to connect the AeroFlow® heater
Prerequisite: Gateway
The Gateway is an optional item and can be purchased via our online shop.
In this menu you will find information about the device, such as the software version.
This display view shows the main details of your device.
Thursday 09:06
Firmware:
System ID:
Heater ID:
IDU:
Menu to reset all configurations to factory settings.
ATTENTION: All personal settings made will be lost!
Follow the instructions on the display.
ARE YOU
COMPLETELY SURE?
The AeroFlow® heater
(!) Keep pressed
left button
to proceed
11
AeroFlow® heater
AeroFlow® heater indicates a lower temperature, use the arrow buttons to increase the value of
to your smartphone or tablet.
restarts and you will see the Status Display view then.
deviates from the real room temperature, a