ThermoTec AeroFlow Mode D'emploi page 10

Smart Start
Use the boost function if you want to increase the room temperature quickly. Press OK to activate the boost function. During boost, the open window detection is deactivated.
Boost
12:34
30:00
Boost
Open the configuration menu.
Configuration
Programs ON
Open window detection
Holidays
Select Time Frame
00:00
Temperature
08:00
11.0°C
16:00
--:--
--:--
--:--
Select Time Frame
00:00
08:00
16:00
--:--
--:--
--:--
Enable or disable Smart Start. When Smart Start is activated, the room will be heated up at the adjusted start time of the respective time frame.
See also page 8: paragraph "Smart Start (adaptive start control)".
Turn Smart Start ON or OFF.
Smart Start OFF
The default setting is 30:00 minutes and it will
how many minutes (selectable in 5-minute steps) the
function.
Use the arrow buttons to switch the programming mode on or off. Confirm with OK.
When "Programs OFF", the menu item "Programs" is not visible. Then you can lower and raise the temperature manually by using the arrow
buttons in the "Status Display" menu instead of (see page 9).
The AeroFlow® heater is able to automatically switch off if an open window detected. In this menu you can switch this function on or off.
Turn on or off the window open detection. When the window open detection is switched on, the AeroFlow®
radiator switches off for not more than 16 minutes if an open window is detected. The next window open detection
takes place at the earliest 20 minutes after the expiry of the 16 minutes.
Detection OFF
The AeroFlow® heater can be switched into holiday mode.
In holiday mode, the program (if active) is disabled for the duration of the absence. If the heater is in manual mode , the preset manual
temperature is disabled for the duration of the absence.
Use the arrow buttons to enter the number of days you are leaving.
Days out:
OFF
Return time:
Use the arrow buttons to set the hour of the desired time of return. Confirm with OK.
09:00
After this, set the minute of the return time and confirm with OK as well.
The return temperature is the temperature that should begin on your return.
Return temperature:
If program is active (menu "Configuration" → Programs = ON), the return temperature can not be selected. After
15.0°C
reaching the return time the heating plan will be continued. If no time frame is active (paused heating between two
time frames), the Antifreeze temperature is applied. So the heating plan continues as programmed.
If program is disabled, you can use the arrow keys to set the return temperature. Confirm with OK. The status
display with the suitcase icon and the number of remaining days off will appear. The absence temperature
corresponds to the Antifreeze temperature.
To change the temperature for your absence, press an arrow key in the status display. The Temperature-overview
display appears. Change the absence temperature with the arrow keys and confirm with OK. To deactivate the
holiday mode set "days out" to "-" (not "0"). During holiday mode you can change the Antifreeze temperature in
the Antifreeze menu, but this will not be applied for the current absence.
10
Use the arrow buttons to select the temperature for the respective time frame.
08:00 1e1,0°C
Confirm with OK.
16:00 19,0°C
00:00 11,0°C
--:-- -- °C
--:-- -- °C
--:-- -- °C
After entering all desired time frames, the "arrow-down"-button must be pressed
08:00 11,0°C
again. The "arrow-back"-symbol will appear on the display. Press OK to fully exit
16:00 19,0°C
the programming mode now.
00:00 11,0°C
--:-- -- °C
--:-- -- °C
--:-- -- °C
count down immediately. You do not need to press any further button. Use the arrow buttons to set
AeroFlow® heater will heat permanently for the preset time. Press OK to cancel the boost
is