Installation Requirements - FS AP-T565 Guide De Démarrage Rapide

Button
Reset
LEDs
LEDs
SYS
Signal strength indicator
(3 lights only light up while
bridging)

Installation Requirements

Install the AP indoors.
Make sure the floor of the installation site is dry and flat.
Place the AP in a dry area and avoid liquid intrusion.
Keep the AP and installation tools away from walkways.
Do not power the AP during installation.
Install the AP in a well-ventilated location.
Keep away from high voltage cables.
Keep the AP clean and dust-free.
Description
Restart: Press the Reset button for less than 2 seconds.
Restore to Factory Default Settings: Press the Reset button for more
than 3 seconds.
State Description
In progress of initialization.
Blinking Green
Normal operation.
Solid Green
Initialization is complete without a CAPWAP
Solid Orange
connection.
Initialization is complete, but the Ethernet link is
Blinking Red
down.
1 Light On Signal strength: ≤-70dBm
2 Lights On
Signal strength: -70dBm~ -50dBm
3 Lights On Signal strength: ≥-50dBm
Signal strength indicator
SYS
4