FS AC-7072 Guide De Démarrage Rapide page 13

Con guring the Wireless LAN Controller
Con guring the Controller Using the Console Port
Step 1: Connect a computer to the controller's console port using the supplied console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 9600 bits per second, 8 data bits, no parity, 1 stop bit
and no ow control.
Quick Connect
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Step 4: After setting the parameters, click Connect to enter.
12
Serial
COM3
9600
8
None
1
Show quick connect on startup
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
Save session
Open in a tab
Connect Cancel
x