Moulinex PRINCIPIO LM100088 Mode D'emploi page 9

• Cut all the ingredients into cubes and then place them in the blender jug
• It is best to start with liquids. Do not go over the maximum level shown on the jug (1L).
• You can add ingredients through the measuring cap hole while the appliance is running.
• Fit the lid (B) to the blender jug
• Connect the appliance
• To start the appliance, turn the control dial
GB
position.
• To stop the appliance, set the control dial
• Wait for the appliance to come to a complete stop before removing the jug.
• Remove the jug by unlocking it in the opposite direction to assembly
CAUTION: Never pour or mix liquids or food whose temperature is higher than 80°C (175°F) into the jug.
When mixing hot food (which is below 80 C (175 F) , keep your hands away from the lid and the cap to
avoid any risk of burns or scalds.
Cleaning
• Disconnect the appliance.
• Remove the jug and rinse it and its lid under running water.
• Wash the jug and lid in hot water with a few drops of washing up liquid.
• You can wash the blender jug and lid in the dishwasher.
• Clean the body of the appliance
• Never immerse the body of the appliance under water or put it under running water.
• Handle blades with care. They can cause injury.
Problems
Product does not work.
Excessive vibration.
Leak from lid.
Blade does not turn easily.
What if your appliance still does not work?
• Contact an authorised service centre (see service handbook).
(C)
.
(E)
(E)
(D)
with a moist cloth. Dry thoroughly.
What to do if your appliance does not work?
The plug is not connected.
The jug or accessory is not fitted
correctly on the body of the
appliance.
The product is not placed on a flat
surface.
The jug or accessory is not
correctly fitted to the body of the
appliance.
Too great a volume of ingredients.
The lid is not correctly positioned.
Pieces of food too big or too hard.
to position "1" or "2" OR apply a few pulses using the "PULSE"
back to "0".
(see figure3)
Causes
12
(C)
.
.
Solutions
Connect the appliance to a socket
with the same voltage.
Check for correct positioning of
the jug.
Place the appliance on a flat
surface.
Check for correct positioning of
the jug.
Do not go over the maximum level
indicated on the jug (1L).
Check lid is correctly positioned on
jug.
Reduce size or quantity of food. Add
liquid.