Maintenance Schedule - Aqua-Base ZD 12 Manuel Utilisateur

AQUA-BASE
6. OPERATING OF
61. STARTING-UP
Open the hull valve (V0),
-
Check that the inlet valve (2) is in sea water feeding position,
-
Press on the green ON button,
-
Adjust the pressure by using the pressure regulating valve, when
-
needed,
After a few minutes, check that the
-
producing correctly.
63. RINSING
WARNING : The rinsing should be carried out before stopping the unit for a short time. In case of prolonged stopping, proceed with
the preservation operation. Rinsing and preservation need the use of an auxiliary bucket, for example a household bucket, which
should be perfectly clean and FREE OF ANY TRACES OF GREASY SUBSTANCE
1. Fill the bucket with 10l of water produced by the
add a pinch of preservation solution
2. Immerse the rinsing piping (E) to the bottom of the bucket.
3. Set the inlet valve (2) to Rinsing position.
4. Close the air bleed valve at the top of the filter.
5. Completely open the pressure regulating valve (12) by turning anti-clockwise.
6. Start up the unit by pressing on the green ON button and keep a check on the water level in the bucket.
7. As soon as the bucket is empty, stop the unit by pressing the red OFF button.
8. Put the inlet valve (2) back to its sea water feeding position.
9. Open the air bleed valve.
64. PRESERVATION
WARNING : Preservation should imperatively be carried out before stopping over a long period (wintering)
1. Rinse according to the above method.
2. Fill the bucket with 10l of water produced by the
752039.
WARNING : If the unit is to be out of use in a temperature below 0°C, 20% of
to the preservation solution, during its preparation.
3. Feed the AQUA-BASE unit with this solution according to the procedure described in Chap. 63 points 2 to 9.
4. Take out the filter cartridge and rinse it in fresh water.
NOTA : In order to avoid RINSING and PRESERVATION procedures during immobilisation of the unit, operate the unit for a few
minutes every week.
7. MAINTENANCE
AQUA-BASE
The unit must be maintained regularly in order to avoid the occurrence of defects which could alter its efficiency, its operating
and its reliability. The intervals between maintenance of the

71. MAINTENANCE SCHEDULE

OPERATION
Replacement of filter cartridge
Replacement of the belt
Checking oil level
Oil change
Cleaning the cell
Cleaning the membranes
On this basis the user will adapt his own maintenance schedule, which will depend on his personal use of the unit.
72. SPARE PARTS FOR ONE YEAR Ref. 752046
The spare parts set for one year
QTE/QTY REFERENCE
2 711019
1 752038
752039
1
1 752037-EXP10
DESALINATION UNIT
AQUA-
BASE unit is operating and
AQUA-BASE
AQUA-BASE
, reference 752039.
AQUA-BASE
AQUA-BASE
FREQUENCY
When it is clogged and at when wintering
When it is worn
Every week when used regularly
Every year when restarting the unit
Every year when restarting the unit
Every year when wintering
AQUA-BASE
, Ref 752046 contains all the necessary parts for maintaining the
DESIGNATION
Cartouche de filtre
Huile pompe HP (0.5 litre)
Solution de stockage
Kit nettoyage A+B
62. STOPPING
Press on the red OFF button,
-
Shut the hull valve (V0),
-
If the unit is to be out of use for a short time, less than 2
-
weeks, proceed with rinsing (Chap. 63). If it is to be out of
use for a long time proceed with preservation (Chap. 64).
.
unit, or failing this, unchlorinated fresh water; to dechlorinate mains water, just
unit and dissolve one dose of preservation solution,
AQUA-BASE
unit depend on the frequency and conditions of use.
DESCRIPTION
Filter element
Hp pump oil (0.5 litre)
Preservation chemical
Cleaning kit A+B
AQUA-BASE
®
ANTI-FREEZE ref.752004 must be added
MINI
1 year
1 year
1 year
1 year
AQUA-BASE
VERSION 01/2007
AQUABASEZD 01-2007 FR-GB.doc
reference
desalination unit.
FR/GB Page 15/26