Electronic Key And Antitearing Protection Tamper - Hiltron security TM Serie Manuel D'utilisation

security
2.3.1

Electronic key and antitearing protection tamper

Alarm
NA C NC
SKI/NL
A
B
C
D
* This connection will activate the 24h anti-sabotage protection alarm when a false key is
inserted in the SKI connector.
NOTE: It a telephone diallers with escape exits relay to see out line pag.9
ANTITEARING PROTECTION TAMPER (Protec Series only)
6mm hole for antitearing tamper
Perform a 6mm hole and insert the plug supplied. .
Tighten the screw until the boss useful. It will
activate the tamper on the back of the central series
PROTEC
Installation tamper on PROTEC base
Insert into the hole in the plastic support provided.
Plug the cable to the card.
Secure with 2 screws the tamper base of
the plant, making sure that the tamper spring going
to fit into the plastic base.
Connecting to tamper central
The tamper should be connected to the terminal on
the 24H of the plant, using the supplied cable.
- -
+ + +
- 12Vcc int12V Chiave
Sir S.A.
Remove
the arch
+
R Com
V
led key zone
In series to the 24h line
ATTENTION! Optional connection*
ANTITEARING
TAMPER
2 screw
for fixing
on base
PROTEC series
24H Z1 Z2 Z3 Z4 Z5 Z6 Z7 Z8
NC NA C NC NA C V R A B C D
Uscita
Chiave Falsa
Plastic
support
Installation
SK100
+
LED INSERITORE 12V
screw +
anchor
23