Klein Tools CL210E Mode D'emploi page 9

AC/DC VOLTAGE (LESS THAN 600 V)
1. Insert the RED test lead into the VΩ jack
test lead into the COM jack
switch to the DC voltage
2
Note 'DC' or 'AC' on the display.
2. Apply test leads to the circuit to be tested to measure the
voltage. The meter will auto-range to display the measurement
in the most appropriate range.
NOTE: If '–' appears on the LCD, the test leads are being applied
to the circuit in reverse. Change the position of the leads to
correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of the order mV may appear on the display. This is noise
and is normal. By touching the test leads together to close the
circuit, the meter will measure zero volts.
NOTE: To access the mV range for V AC,
must be used.
7
OPERATING INSTRUCTIONS
4
Black lead
5
, and rotate the Function selector
or AC voltage
Red lead
OR
the 'RANGE' button
and the BLACK
setting.
9