Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
CONNECTING TEST LEADS
Do not test if the leads are improperly seated. Results could cause
intermittent display readings. To ensure a proper connection, press
the leads firmly into the input jack.
CORRECT
INCORRECT
TESTING IN CAT III/CAT IV MEASUREMENT LOCATIONS
Ensure that the test lead shield is pressed firmly into place. Failure
to use the CATIII/CATIV shield increases the risk of arc flash.
5/32"
(4 mm)
TESTING IN CAT II MEASUREMENT LOCATIONS
CAT III/CAT IV shields may be removed for CAT II locations. This
will allow testing on recessed conductors such as standard wall
outlets. Take care not to lose the shields.
.7" (18 mm)
7
Publicité
Table des Matières
