Wavetek Meterman AD40A Manuel D'utilisation page 22

Pinces de courant ca à mesure moyenne et indication de valeur efficace (onde sinusoïdale)
Table des Matières

Publicité

F • Remplacement de la Pile
L'instrument est alimenté par deux piles de 1.5V AAA. Remplacez les piles dès
que U est affiché.

Dévissez et enlevez le boîtier arrière.
le boîtier.
Read the warranty located at the front of this manual before requesting war-
ranty or non-warranty repairs. For warranty repairs, any multimeter
claimed to be defective can be returned to any Wavetek Meterman autho-
rized distributor or to a Wavetek Meterman Service Center for an over-the-
counter exchange for the same or like product. Non-warranty repairs
should be sent to a Wavetek Meterman Service Center. Please call Wavetek
Meterman or enquire at your point of purchase for the nearest location and
current repair rates. All multimeters returned for warranty or non-warranty
repair or for calibration should be accompanied by the following informa-
tion or items: company name, customer's name, address, telephone num-
ber, proof of purchase (warranty repairs), a brief description of the problem
or the service requested, and the appropriate service charge (for non-war-
ranty repairs). Please include the test leads with the meter. Service charges
should be remitted in the form of a check, a money order, credit card with
expiration date, or a purchase order made payable to Wavetek Meterman
or to the specific service center. For minimum turn-around time on out-of-
warranty repairs please phone in advance for service charge rates. The
multimeter should be shipped with transportation charges prepaid to one
of the following addresses or to a service center:
Œ
Coupez l'alimentaton de l'appareil et enlevez les cordons.
REPAIR
– 19 –

nen.
Zwei Schrauben von
Rückseite
Geräterückseite
Batterien ersetzen und Gerät wieder
zusammensetzen.
E • Sustitución de las Pilas
El medidor está alimentado por dos
baterías del tipo botón de 1,5
voltios AAA unitarios. Cambie las
baterías, tan pronto como aparezca
el símbolo U en pantalla.
Apague el medidor. Desconecte y
retire las puntas de prueba.
Ponga el medidor mirando hacia
abajo. Extraiga los dos tornillos y
levante la tapa posterior.
Cambie las pilas. Vuelva a cerrar
la tapa.
Ž
Remplacez les piles et réassemblez
entfernen
und
Ž
abheben.
Œ

Ž

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ac40a

Table des Matières