Data Memory; Viewing The Stored Values; Memory Full; Clear All Values - Spengler ES-60 Manuel D'utilisation

FR

7. DATA MEMORY

At the end of a measurement, this instrument automatically stores each result,
including date and time.
EN

7.1. Viewing the stored values

This blood pressure monitor automatically stores the last 60 measurements
values. By pressing the M button after O/I initiated and "0" reset is done, the last
measurement (MR60) as well as the previous 59 measurements (MR59, MR58,
ES
...MR1) can be displayed one after the other. Data obtained in Average Mode are
indicated by a MAM symbol. Pressing the M-button repeatedly enables you to
toggle between one stored value and another.
Note: press the «Time/MAP» button during memory display to check the MAP:
IT
Mean Arterial Pressure.

7.2. Memory full

Pay attention that the maximum memory capacity of 60 is not exceeded. When
DE
the memory is full, the old values are automatically overwritten with new ones.
Values should be evaluated before the memory capacity is reached - otherwise
data will be lost.

7.3. Clear all values

NL
If you are sure that you want to permanently remove all stored values, hold down
the M-button after O/I initiated and "0" reset is done, until CL appears and then
release the button. To permanently clear the memory, press the M-button while
CL is flashing. Individual values cannot be cleared.
AR
26