Installing The Handle; Installing The Feet - Clarke HOT SHOT SPOOL GUN WELDER FLUXCORE/MIG 135SG Mode D'emploi

ASSEMBLE THE FACE SHIELD
1. Remove the lens retaining pegs and
shield handle nut from the arm of the
shield handle. (DO NOT DISCARD!)
2. Place the shaded lens into the space
provided on the inside of the face shield.
3. Screw the lens retaining nuts into the
holes to either side of the lens until they
are tight against lens.
4. Insert threaded peg on shield handle into
hole on face shield. Press firmly until
threaded peg and smaller peg below it
are locked into place.
5. From inside of shield, screw the shield
handle nut tightly onto peg threads.
See Figure 2 for face shield assembly.
Figure 2. Face Shield Assembly

INSTALLING THE HANDLE

1. Insert the tabs of the welder handle into the
slots provided on the top of the welder.
2. Insert a large flat head screw (included in
the accessories bag) into each hole on
the top of the welder handle.
3. With a flat tip screwdriver, securely
tighten both screws. (see Figure 3)
Figure 3. Handle Installation

INSTALLING THE FEET

Locate the two black plastic feet for the
welder. (The front foot is slightly larger than
the back foot.)
1. Lay the welder on its side.
2. Align the holes of the front foot with the
front screw holes on the bottom of the
welder. The curved face of the front foot
should face the front of the welder.
3. Insert the two Phillips head screws (includ-
ed in the accessories bag) into the holes.
4. With a Phillips head screwdriver, securely
tighten both screws.
5. Align the holes of the back foot with the
rear screw holes on the bottom of the
welder. The curved face of the back foot
should face the rear of the welder.
6. Insert the two Phillips head screws
(included in the accessories bag) into the
holes.
7. With a Phillips head screwdriver, securely
tighten both screws. (see Figure 4)
Figure 4. Feet Installation
INSTALLING THE WELDING TORCH
1. Open the side door of the welder.
2. Loosen and remove the three screws
from the junction box cover.
3. Remove junction box cover from junction
box.
4. Insert Torch Cable through Torch Cable
Grommet on the face of the welder. (See
Figure 5)
5. Place the Torch Cable into the junction
box as shown in Figure 6. Make sure the
outer sleeve of the Torch Cable is resting
in the grooved portion of the junction
box.The gas hose should exit the junction
box at the top. The Power Coupler and
Figure 5.
Torch
Installation
11