USAG 929 PC1 1/2 Notice D'utilisation Et Instructions page 10

PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING PNEUMATIC TOOL
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR HEARING PROTECTION WHILE
OPERATING PNEUMATIC TOOL
ALWAYS WEAR EYE PROTECTION WHILE
OPERATING PNEUMATIC TOOL OR PERFORMING
MAINTENANCE JOBS
Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk
analysis survey if the values exceed the limits under current regulations.
WEAR ANTI-VIBRATION GLOVES WHILE
OPERATING PNEUMATIC TOOL FOLLOWING A
SPECIALLY CONDUCTED SURVEY OF LEVEL OF
DAILY EXPOSURE OF HAND-ARM SYSTEM TO
VIBRATION
SPECIFICATION
Square
Model
Drive
"
943 PC1 1/2 1/2
929 PC1 1/2 1/2
943 PC2 1/2 1/2
Average Air
Model
Consumption
l/min
943 PC1 1/2 172
929 PC1 1/2 172
943 PC2 1/2 167
* k = measurement uncertainty in dB
Air supply connection
For correct use of the pneumatic tool, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the
pneumatic tool with clean, condensate-free air. Excessively high pressure or humidity in supply air results in shorter life for
the mechanical parts and may damage the tool.
EMERGENCY
GATE VALVE
Impact Max Breakaway
Rate speed Torque
bpm rpm Nm
1200 6500 1898
1300 7000 1600
1400 10000 950
Working Weight
Pressure with retainer
bar
6.2
6.2
6.2
** k = measurement uncertainty in m/s²
An air filter unit should be placed between air compressor and air lubricator
to promote clean air supply to the impact wrench Water, dirt, and scale can
damage the impact wrench .
ALWAYS WEAR PROTECTIVE GLOVES AGAINST
PHYSICAL AGENTS WHILE OPERATING
PNEUMATIC TOOL
ALWAYS WEAR SAFETY SHOES
WEAR PROTECTIVE MASK AGAINST PHYSICAL
AGENTS ACCORDING TO THE VALUES FOUND
IN THE ENVIRONMENTAL/INDUSTRIAL HYGIENE
SURVEY
Noise level (ISO 15744)
Pressure dB(A)
k*
94 3 105
93 3 104
95 3 107
Dimensions
with retainer
kg mm
2.2 162 x 75.3 x 212
2 162 x 75.3 x 212
1.4 144 x 62.5 x 197
The air tool must be lubricated before storing. Follow the
"Lubrication" instruction with exception of step 3.
Always use an air line lubricator with this tool.
Do not over-oil and do not use heavy grade oil as stalling and
low performance may result.
10
Vibrations
level
m/s
2
Power
(ISO 28927)
dB(A)
k* k**
3 6.4 2.2**
3 6.2 2.5**
3 3.9 1.5**