USAG 929 PC1 1/2 Notice D'utilisation Et Instructions page 11

FORWARD/REVERSE AND SPEED CONTROL
The forward/reverse and speed control switch (Fig.
1) determines the direction of the tool and also
serves as the variable speed control. To select full
speed forward rotation, turn the switch to the far
right side of the tool as shown.
To select reverse, turn the switch to the far left side
of the tool as shown. Please note, reverse is always
full power.
Forward rotation can be adjusted for variable speed
by turning the lever between the three settings as
shown in Fig 1, switch will detent in each position.
LUBRICATION/GREASING
The pneumatic tool must be connected to a filter-lubricator unit (we recommend USAG item 930) provided with an air-oil microfog
mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole.
CAUTION: This air tool requires lubrication BEFORE initial use, also before and after each additional use.
To Lubricate the Air Tool Manually:
1. Disconnect the tool from the air supply source, place the air inlet face up.
2. Depress the trigger and place about 0.15 to 0.25 ml of air tool oil into the air inlet.
NOTE: Use SAE #10 weight oil if air tool oil is not available.
3. Remove accessory, connect the tool to an air source, then cover the exhaust end with a towel and run tool for 2 to 3
seconds.
To lubricate internal mechanism:
Locate the grease fitting on the back of the tool (fig. 5). Inject 4 grams of
approved impact grease into the fitting every 3-5 months depending on use.
Use recommended grease gun nozzle tip (fig. 6) on grease fitting,
smaller or sharp nozzle will damage grease fitting ball bearing.
WARNING: Keep out of the reach of children. If air tool oil is ingested, do not induce vomiting, call a doctor immediately.
WARNING: Any excess oil in the tool is immediately expelled from the exhaust port. Always direct exhaust port away from people or
objects.
NOTE: Check the speed and make a simple check of the vibration level after each service.
Fig. 5
Fig. 1
Fig. 1
FORWARD - SPEED SETTING 1
FORWARD - SPEED SETTING 1
FORWARD - SPEED SETTING 3
FORWARD - SPEED SETTING 3
Fig. 6
3.0mm
GREASE NOZZLE
TIP
11
FORWARD - SPEED SETTING 2
FORWARD - SPEED SETTING 2
REVERSE
REVERSE