Fitting The Wall Bracket - StarLab StarPet Pro E4866-0021 Manuel D'utilisation

RECHARGING
Before starting to operate, carefully check mains voltage and recharge batteries.
To charge the StarPet Pro:
1 Recharging temperature +10°C to +35°C.
2 Plug the charger jack (6) into the base of the StarPet Pro.
3 Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
4 Place StarPet Pro on bench stand.
5 Allow unit to charge for 14 hours from empty to fully charged.
6 Once the StarPet Pro is fully charged, the charger automatically switches to a trickle charge
and the red indicator will turn off. If the charge to the StarPet Pro is interrupted and then re-started,
the charger starts its full 14-hour charging cycle again. This will not damage the battery.
7 Only use the charger indoors and protect against moisture.

FITTING THE WALL BRACKET

The StarPet Pro bench stand is supplied ready to use as a wall bracket. When used as a bench stand it is
recommended that the wall fitting section is removed.
Bench Stand Wall Bracket
StarPet Pro Operator Instructions 5