Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Français
Deutsch
Italiano
English
INTRODUCTION
The StarPet Pro has been carefully designed and manufactured as a lightweight, cordless pipetting aid for
use with all plastic/glass pipettes in volumes from 1 to 100ml.
Constructed in recyclable materials, the StarPet Pro operates on two rechargeable, long-life,
environmentally friendly, 1.2V nickel metal hydride batteries, and has uniquely formed finger triggers to
minimize any high pressure points. These triggers also control the intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low to let you know the
batteries should be recharged. Pipetting with a StarPet Pro can also take place while the unit is connected
to the charger (5).
The StarPet Pro has a conveniently located slide switch (3) which allows you to select between three
modes of operation:
Slide switch position 'High' (top)
Slide switch position 'Low' (middle)
Slide switch position 'G' (bottom)
TECHNICAL DATA
Batteries
Battery service Life
Charger
Overall weight
Filter (8)
Case material
Nosecone material (10) ASA
Pipette holder (9)
Pipette types
2
2 – 8
9 – 15
16 – 22
23 – 29
Suction and dispense at full speed (Blow-out)
Suction and dispense at reduced speed (Blow-out)
Suction at reduced speed, dispense by gravity (To Deliver)
2 x 1.2V nickel metal hydride
500–1000 cycles from empty
75mA/h for 14 hours plug-in;
UK, European, USA, Indian, Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
180g without stand
Hydrophobic 25mm dia 0.45μm (fitted), plus two additional spare filters
1 x 0.45μm
1 x 0.20μm
ASA
Silicone
Plastic or glass 1–100ml
StarPet Pro Operator Instructions
Publicité
Table des Matières
