Publicité
Les langues disponibles
Les langues disponibles
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
b) Partially remove the protective film on both sides and assemble the rear windshield (Item A)
and the OEM rear screen guard to the vehicle roll-cage using supplied hardware (Item B) as
shown below. Adjust the position of the windshield and tighten all screws.
Button head
screw M6 x 45
Domed shoulder
washer M6
Internal lock
washers M6
Domed shoulder
washers M6
Button head
screws M6 x 45
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
▪ Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
▪ To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
2513 - Instructions KAWASAKI MULE SX Rear Windshield - Rev00
IMPORTANT NOTICES
Nylon
spacers ¾"
Internal lock
washer M6
▪ Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
light transmission and coating delamination.
▪
Aqueous Solution of Soaps and Detergents
Joy
Freon T.F.
Palmolive liquid
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
warranty.
locknut M6
Nylon
spacer ¾"
CLEANING:
or use brushes or squeegees.
rinse. DO NOT USE GASOLINE.
Compatible Cleaning Agents
Top Job
Nylon
Plastic shoulder
washers M6
Plastic shoulder
washers M6
VM&P grade Naphtha
Windex
(with ammonia D)
www.kolpin.com
Nylon
locknuts M6
2
Publicité
