Publicité
Les langues disponibles
Les langues disponibles
of two transport wheels on the reverse side of the stand, as illustrated. The
roller configuration features a 4 castor base plate, with removable legs. An
optional base plate is available allowing the turnbuckle configuration to be
mounted on a 4 castor base plate using 4 M8 securing holes, thus allowing it
to operate in the same manner as the roller configuration.
3. Safety Precautions
The Zenith stands provide easy and smooth lifting and lowering. The user
must determine if the product has the necessary characteristics to fulfil the
required application.
Excluded applications:
-
Not tested for construction hoists
-
Not approved for lifting persons
-
Not approved for motorised use
Automatic mechanical brake: The TÜV approved winch used on these
stands is fitted with an automatic brake. The minimum load as marked on
the stand should be met to ensure the brake performs correctly. For any
matters relating to the winch, please refer to the winch operating
instructions supplied.
Note: Do not apply oil or grease to the brake mechanism. The brake
washers are pre-greased with pressure resistant grease.
Before loading, the stand must be placed on a suitably firm and level
surface, with the stabiliser legs in place and in firm contact with the
ground. Confirm that the mast section is vertical by using the spirit level
attached.
The cable should be visually inspected at all accessible points for frays,
cuts or kinks before the stand is used. If any defects are found then the
stand should be removed from service until a suitable repair can be made.
Do not attempt to use the stand with a damaged cable. Do not shorten the
cable at the winch connection.
The winch handle must not be removed from the stand while a load is
fitted, as this will disengage the brake and allow the load to drop. The
minimum load as listed on the table above and on the stand must be met to
ensure correct braking action on the winch.
If using the stand in open air, ensure the stand is firmly supported by guy
ropes to allow for weather conditions.
The stand should not be moved with a load attached, either extended or
3
Publicité
