ASROCK H55M Mode D'emploi page 12

Table des Matières

Les langues disponibles

2. 2. 2. 2. 2. Installation

Installation

Take note of the following precautions before you install mother-

board components or change any motherboard settings.

1. Unplug the power cord from the wall socket before touching any

component. Failure to do so may cause severe damage to the

motherboard, peripherals, and/or components.

2. To avoid damaging the motherboard components due to static

electricity, NEVER place your motherboard directly on the carpet

or the like. Also remember to use a grounded wrist strap or touch

a safety grounded object before you handle components.

3. Hold components by the edges and do not touch the ICs.

4. Whenever you uninstall any component, place it on a grounded

antstatic pad or in the bag that comes with the component.

5. When placing screws into the screw holes to secure the

motherboard to the chassis, please do not over-tighten the

screws! Doing so may damage the motherboard.

2.1

2.1 CPU Installation

CPU Installation

2.1

CPU Installation

For the installation of Intel 1156-Pin CPU,

please follow the steps below.

Before you insert the 1156-Pin CPU into the socket, please check if

the CPU surface is unclean or if there is any bent pin on the socket.

Do not force to insert the CPU into the socket if above situation is

found. Otherwise, the CPU will be seriously damaged.

Pre-installation Precautions

ASRock H55M Motherboard

1156-Pin Socket Overview

Table des Matières