Attach Cooktop To Countertop - KitchenAid SCS3017 Manuel Du Propriétaire

Table de cuisson à gaz encastrée

Masquer les pouces

Table des Matières

Les langues disponibles

Typical flexible connection

1. Apply pipe-joint compound made for use with Propane gas to

the smaller thread ends of the flexible connector adapters

(see G in the following illustration).

2. Attach one adapter and nipple to the gas pressure regulator

and the other adapter and nipple to the gas shut-off valve.

Tighten both adapters and nipples.

3. Use a 15/16" (24 mm) combination wrench and pliers to attach

the flexible connector to the adapters. Check that connector is

not kinked.

A. 3/8" (9.5 mm) nipple

B. 3/8" (9.5 mm) adapter

C. Flexible connector

D. 1/2" (13 mm) nipple

E. Gas pressure regulator

F. 1/2" (13 mm) adapter

G. Use pipe-joint compound

H. Manual gas shut-off valve

Complete Connection

1. Open the manual shut-off valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

2. Test all connections by brushing on an approved noncorrosive

leak-detection solution. Bubbles will show a leak. Correct any

leak found.

3. Remove surface burner caps and grates from parts package.

Align notches in burner caps with pins in burner base. Burner

caps should be level when properly positioned. If burner caps

are not properly positioned, surface burners will not light.

Place burner grates over burners and caps.

A. Igniter electrode

B. Burner cap

C. Burner base

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

4. Plug into a grounded 3 prong outlet.