Important - Remington REVEAL MAN3000 Mode D'emploi

ENGLISH
PARTS
1. Power connector
2. Power button
3. Direction/speed controls
4. Lighted tip
5. Spindle
6. Needle Milling Cutter
7. Flame Milling Cutter
8. Sapphire Cone
9. Cylindrical Milling Cutter
10. Tapered Callus Rasp
INTRODUCTION
This manicure and pedicure device comes with 12 high-quality accessories and a number of
these are made with a durable sapphire coating and or/polishing felt. With a choice of two
speeds, fully lighted tip for precision detailing, together with right and left rotation, it is
possible to achieve salon quality results with the use of this device.
INSTRUCTIONS FOR USE

IMPORTANT:

• During use, this device can create large amounts of heat through friction. Check the
results regularly during treatment. Pay attention if you, or persons being treated, are
insensitive to heat or have a lowered sensitivity to pain. If you have any doubts, consult
a physician.
• Always start teatment on a low speed setting.
• When treating calluses do not remove all of the callus so as not to compromise the
natural protection of the skin.
1. Connect the power supply to the power connector. Plug the power supply in to the
mains supply socket.
2. Ensure that the device is switched off.
3. Select the desired attachment and push it firmly into the spindle opening (FIG A).
4. Press the power button (C). The light will come on.
5. The device can rotate clockwise or anticlockwise. Select the direction by pressing one of
the direction/speed buttons (ƒ„). This will start the device in the direction chosen at
low speed. Pressing the same button again will change the speed to high.
6. To stop the device, press the power button.
7. To remove an attachment, ensure that the device is switched off then pull the
attachment straight out of the spindle.
4
11. Felt Cone
12. Sandpaper Barrel Attachment (10x refills)
13. Sapphire Disk (Fine)
Not shown:
14. Power Supply
15. Nail Clipper
16. Cuticle Pusher
17. Toe Separators (x2)
18. Cleaning Brush
19. Storage Case