Transmitter Control - Horizon Hobby BLADE MQX Mode D'emploi

Transmitter Control

A
H
G
F
When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing. The middle
or neutral trim position is heard as a middle tone in the pitch range of the sounds. The end of the control range is
sounded by a series of beeps.
H A
Mode 1
Power
LED
Mode 2 Power
LED
RTF
Transmitter Dual Rates
Your mQX RTF model comes with the Blade MLP4DSM transmit-
ter. This transmitter's dual rate feature lets the pilot change
between high and low control rates for the aileron, elevator and
rudder channels.
• When powered on, this transmitter is automatically in
high-rate mode.
• Change rate modes by pressing and releasing the right
control stick while the transmitter is powered on.
• Low-rate mode is shown by the transmitter's LED blinking
continuously. In this mode, the controls cannot reach
their maximum values. This mode is typically preferred by
pilots looking for smoother/easier control response
during first time use.
• High-rate mode is shown by the transmitter's LED glowing solid red. In this mode, the controls can reach
their maximum values. This mode is typically preferred by experienced pilots who are ready for fast forward
flight and aerobatic maneuvers (loops, rolls, etc.).
EN
B C
Aileron (Left/Right) Throttle
Throttle (Up/Down) Trim
Aileron (Left/Right) Elevator
Elevator (Up/Down) Trim
E
D E F
Aileron ON/OFF Rudder
Trim Switch Trim
Aileron ON/OFF Rudder
Trim Switch Trim
8
B
C
D
G H
Elevator Rudder (Left/Right)
Trim Elevator (Up/Down)
Throttle Rudder (Left/Right)
Trim Throttle (Up/Down)