Honeywell CL25AE Série Mode D'emploi page 4

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
MODE
Press the MODE button to select COOL and FAN modes. Pressing the MODE button until COOL is
illuminated on the control panel activates evaporative cooling. The water pump will operate and you will
feel the cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button until Fan is illuminated switches the unit to a fan only mode, without
evaporative cooling.
ROOM COOLING AND HUMIDIFYING
In cooling mode, Honeywell Air Coolers provide moisturized air
Water Regulator
through the evaporation of water. There is a manual Water Regulator
knob located in the ice compartment of the unit. This allows you to
adjust the amount of water pumped over the Honeycomb Cooling
Media, thus helping to control cooling and humidification levels.
MIN
When the Water Regulator is set to MIN, the water pump distributes
a minimal amount of water to the Honeycomb Cooling Media. This
MAX
results in less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes
the maximum amount of water to the Honeycomb Cooling Media. This
results in maximum water evaporation and the cooling performance
improves.
EN 3