Connecting The Receiver - Conrad Electronic GH-818 Mode D'emploi

Considering the variety of lacquers and polishes used with furniture, it is pos-
sible that the feet of the device could leave visible marks on furniture due to a
chemical reaction. For this reason, the device should not be set on furniture
surfaces without suitable protection.

Connecting the receiver

Only use isolated microphone wires for connecting to the receiver
output. Using other cables may lead to disruptions.
In order to avoid distortions or mismatching that may damage the
microphone and the connected audio device, the product may
only be connected to suitable microphone or audio inputs.
Should your audio device not fit with the corresponding socket
connections of the receiver, please use a suitable adapter.
Switch off the receiver.
Switch off the audio device (mixer, etc.)
to be connected to the reciever and
disconnect from the power supply.
Connect the microphone or audio input
of the audio device with the AF OUT-
PUT (5) of the receiver.
Adjust the LEVEL (6) toggle to the cor-
rect output voltage.
Plug the enclosed antenna into the ANT
(8) antenna connection of the receiver
and securely fasten the cap nut.
24
All manuals and user guides at all-guides.com
Press the POWER (1) switch, the built-in
LED should not shine.
Should the audio device have a low lev-
el voltage for the microphone input,
switch off the low level voltage.
Position MIC for connection to a micro-
phone input, position AUX for connec-
tion to a LINE input.
Next the antenna should be vertically
adjusted.
• For safety reasons, always pull the power adapter from the outlet during a thun-
derstorm.
• Do not listen to music at an excessive volume over longer periods of time.. This
may damage your hearing
Maintenance
Regularly inspect the mechanical safety of the cordless microphone system, e.g. for
damage to the power cable and housing.
If it has been ascertained that safe operation is no longer possible, take the device
out of operation and secure it against accidental reactivation. Pull the power adapter
from the outlet and remove the battery from the microphone!
It is ascertained that safe operation is no longer possible, if:
• the device or power adapter shows visible damage
• the device no longer works
• after longer storage under unfavourable conditions or
• after heavy transport stresses
Make sure you observe the following safety instructions prior to cleaning or
servicing the microphone:
When opening covers or removing parts of the casing, you may
expose live parts.
Before performing maintenance or repair work, disconnect the
device from all voltage sources.
Condensers in the device may still be charged, even if the device
was disconnected from all voltage sources.
A repair may only be performed by a specialist familiar with the
associated hazards and appropriate regulations for the device.
29