Residual Risks - Battipav Queen 818 Mode D'emploi

GB
CAUTION
BEFORE PERFORMING THE CUTTING OPERATIONS,
MAKE SURE THAT THE MATERIAL IS PROPERLY
LEANED AGAINST THE TILE STOPPER.
CAUTION
Position the cutting guide, then lock it by tighten the
knobs fully.
CAUTION
9 Figure 9 shows the correct hand position during
90° cutting operations.
The forward movement of the piece must be
proportional to the blade cutting capacity,
to prevent hazardous fragments which could cause
accidents or injuries from breaking off.
CAUTION
CHECK THE WATER LEVEL
CUTTING A SURFACE AT 45°
CAUTION
Put the tilting table in the 45° position by means of
the tilting table support rods; position the tile bearing
square, making sure that the diamond blade does not
come into contact with the tile enamel.
CAUTION
10 Figure 10 illustrates the correct position of the
hands in the case of 45° angle cuts.
Note that the right hand holds the piece in
contact with the diamond blade, while the left
hand moves the piece forward.
The forward movement of the piece must be
proportional to the blade cutting capacity,
to prevent hazardous fragments which could
cause accidents or injuries from breaking off.
20
CAUTION
CHECK THE WATER LEVEL

RESIDUAL RISKS

During the design phase, BATTIPAV SRL paid
particular attention to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION
• Danger of presence of electric current.
The machine has an internal electric system:
CONNECT THE MACHINE TO A SYSTEM WITH
DIFFERENTIAL PROTECTION AND EFFECTIVE
EARTH WIRE.
CAUTION
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST
DEFENDERS.
CAUTION
• Danger of exposure to fragments of materials.
OPERATORS MUST
GOGGLES.
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES.
ALWAYS STAY IN THE WORKING POSITION (Pos.
1 picture 8) DURING THE MACHINE OPERATION
PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.
Battipav srl
USE PROPER EAR
WEAR PROTECTIVE