Checking And Changing The Time Display Mode; Setting The Time - VICTORINOX SWISS ARMY Chrono Classic XLS MT Mode D'emploi

a rapid rotation advances or retracts the hands by one full hour,
a slow rotation enables the minutes setting to be corrected.
– Push the crown back down.
– Select the function for local time (Fig. 2).
– Proceed to time setting (3. Setting the time).

2. CHECKING AND CHANGING THE TIME DISPLAY MODE

There are 2 time display modes:
– once 24 hours
– twice 12 hours:
AM from midnight to midday
PM from midday to midnight.
– Select function from T2 (Fig. 6).
To check the display mode:
– Push the crown once. If the letter A or P appears time is displayed in the 12-hour
mode.
– In the 12-hour mode, a small letter P appears between midday and midnight
alongside the numerals displaying the hours.
– Push the crown twice to return to 24-hour mode.
8
English English

3. SETTING THE TIME

Hours and minutes
– Select and display local time (Fig. 2).
– Pull out the crown. The symbol T appears in the upper section
numerals for hours and minutes flash ( ).
– Set the correct time by turning the crown either clockwise or counter-clockwise:
a rapid rotation advances or retracts the hands by one complete hour,
a slow rotation enables the minutes setting to be corrected.
– Push the crown back down.
Fine correction of the second
After the time has been set (3. Setting the time), or after a certain period of time in
operation, if the watch is showing a slight inaccuracy, the time can be set to the
exact second.
How to set the exact second:
– Select and display local time (Fig. 2).
– Pull out the crown. The symbol T appears in the upper section of the dial
the numerals for hours and minutes flash ( ).
– Push the crown back down. The numerals displaying seconds flash for 1 minute.
of the dial and
and
9