Setup Of The Heart Rate Monitor - Crivit Sports 1-LD3473 Mode D'emploi

Setup of the heart rate monitor

Use a coin to unscrew the battery cover on the back side of the chest belt and
insert the 3V battery with the (+) sign facing up. Screw the battery compartment
cover back into the case.
Remove the protective film from the display and press MODE, SEL or SET.
Now select English, German, French or Spanish language by pressing SEL and
confirm your setting by pressing SET.
Select the unit KM-KG
METRIC KM - KG
or Miles/pounds
IMPERIAL M - LB
in the same way. Complete the setting procedure by pressing MODE.
The watch can be reset by pressing and holding SET and SEL together. Only after
reseting the watch the other language can be selected.
All manuals and user guides at all-guides.com
battery CR2032
KM - KG KM - KG
M - LB M - LB
- 75 -
Wearing the chest belt
Adjust the chest belt so that it fits
snugly directly below the chest
muscles. Moisten the contact areas
with water or ECG gel (ECG gel can
be purchased at a pharmacy). Ensure
that the contact areas constantly
remain in skin contact.
Position the chest belt as per the
following illustration.
Please ensure that the chest belt is
seated properly. When you have
exhaled completely the chest belt
should still have very slight tension
pressing it to your chest.
High voltage power lines, Trains or
moving vehicular traffic may interfere
with the heart rate measurement.
Please consider this when planning
your exercise route.
Using the bicycle holder
The included bicycle holder can
be used to attach the wrist watch
to the handlebar of a bicycle.
Press the bicycle holder onto the
top of the handlebar. Handlebars
with an especially large diameter
may require the use of additional
force to snap on the bicycle
holder. The heart rate monitor can
now be attached to the bicycle
holder in the same way that you
would attach it to your wrist.

contact area
- 76 -
