Disassemble / Reassemble And Cleaning Of Rear Internals - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

DISASSEMBLE / REASSEMBLE AND CLEANING OF REAR INTERNALS

REC030
REC031
Part Names and Numbers described in this section:
Top Cocking Knob (#STK008)
Delrin Bolt (#VBT008)
Striker Bolt (#STB002)
Striker Plug (#STP028/STP029)
QUICK CLEAN DISASSEMBLY
Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the Delrin Bolt to slide
out from the rear of the Receiver.
to clean with a squeegee.
Receiver. This will allow the Top Cocking Pin to correctly fasten with the Striker Bolt.
IMPORTANT: The air passage hole located in the middle of the Delrin Bolt should always be facing downward when
reinstalling. If the Delrin Bolt is not installed correctly, paintballs will not exit out of the barrel normally.
DISASSEMBLE OF REAR INTERNALS
STEP 1 Lift upward on the Top Cocking Knob to disconnect the Delrin Bolt from the Striker Bolt. This will allow the
Delrin Bolt to slide out from the rear of the Receiver.
STEP 2 Using an adjustable wrench turn the Striker Plug counter clockwise located at the rear of the Receiver. This
will allow all internal parts such as the Velocity Adjuster & Spring Guide, Striker Spring, Striker Buffer and Striker
Bolt to slide from the rear of the Receiver.
NOTE: Remove the Striker Plug only with the marker in the un-cocked position this will prevent the internals from
springing out because the Striker Spring is compressed.
before removing this will prevent the markers internals from springing out.
STEP 3 Remove items in order; Striker Plug w/Velocity Adjuster, Striker Spring and Striker Buffer.
STEP 4 Slide the Striker Bolt out of the rear of the Receiver.
would be wise to clean any dirt or paint from the inside of the Receiver with a squeegee and wipe the Delrin Bolt
clean with a rag or paper towel. Apply some paintball gun oil on Striker O-ring periodically.
IMPORTANT: It is not necessary to disassemble the rear internals for basic maintenance unless the Striker O-ring
needs to be replaced.
11
VBT008
STB002
HELPFUL TIP: Removing the Delrin Bolt from the Receiver will allow easy access
NOTE: Make sure the hole on the Striker Bolt is facing upright when looking thru the
STK008
STF001
SPR004
Striker Spring (#SPR004)
Striker Buffer (#STF001)
Receiver (#REC030/REC031)
HELPFUL TIP: Placing your finger behind the Striker Plug
HELPFUL TIP: When the internals are removed it
STP028
STP029