Trigger Adjustment; Velocity Adjustment - Spyder ELECTRA WITH EYE Manuel De L'utilisateur

WARNING
• Spyder Electronic Markers are not water resistant.
• Extreme moisture can cause serious damage to any Spyder Electronic Marker.
• Always clean any dirt or paint inside the markers electronics.
• Never attempt to modify the electronics circuitry, doing so will VOID all electronic warranties and
liabilities from Kingman.

TRIGGER ADJUSTMENT

MAGNETIC RESPONSE "SABER" TRIGGER
There are 3 adjuster set screws that allows the adjustment for the trigger pull, the micro switch actuation, a post
travel stop and the magnetic response strength.
The first set screw furthest from the micro switch is for adjusting the amount of resistance force the magnet applies
on the trigger. Adjusting the set screw in will increase resistance and out will reduce it for a lighter trigger pull.
The middle set screw is for adjusting the distance between the trigger and the micro switch. Adjusting the set screw
in will bring the trigger actuation closer giving the trigger a short trigger pull.
HELPFUL TIP: Remember not to over adjust this set screw as you may have the trigger rest against the micro
switch and not allow the micro switch to reset for the next trigger pull.
The third set screw closest to the micro switch is for the post travel of the trigger. It is to stop the trigger from
further back travel after it has actuated the micro switch
VELOCITY ADJUSTMENT INCREASE / DECREASE
VTA028
VTA029
To INCREASE your velocity fps using the Allen wrench, turn the Velocity Adjuster / Spring Guide clockwise.
To DECREASE your velocity fps using the Allen wrench, turn the Velocity Adjuster / Spring Guide counter-
clockwise. NOTE: Allen wrench provided in the spare parts kit.
remove from the rear of the Sticker Plug.
NOTE: The velocity of this paintball marker ranges from approximately 240 – 300 feet per second (fps). Velocities
will fluctuate or vary due to paintball size, climate condition, altitude, type of air source and variance in spring
tension from manufacturing.
WARNING
• The recommended Velocity speed should be no greater then 300 fps. Not doing so can cause serious injury or death
if the velocity is set dangerously high.
• Paintball markers are not intended to shoot any person less then 25 feet without eye/face protection.
• Never point a loaded marker at any person who is not wearing the proper face protection.
• Never at any point should you look down the barrel, whether the marker is loaded or not.
• Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law
enforcement penalties if property damage is caused by the user.
SCR029
STP028
STP029
NOTE: Velocity Adjuster / Spring Guide doesn't
English
8