UMP401
OPERATING INSTRUCTIONS
Power On/Off Button
1
Press the power
button (1) (or any button
except eject or release) to turn the unit on.
Press and hold the power
button to turn the
unit off.
Audio MUTE
1
Press the power/MUTE button (1) to silence the
volume from the system. "MUTE ON" will
appear on the display panel. Press MUTE
again to return the volume level to the setting
that was in use before the Mute function was
activated.
Liquid Crystal Display Panel
2
The Liquid Crystal Display (LCD) panel displays
the frequency, time and all activated functions.
NOTE: It is a characteristic of LCD panels
that, if subjected to cold temperatures for an
extended period of time, they may take
longer to illuminate than under normal
conditions. In addition, the visibility of the
numbers on the LCD may slightly decrease.
The LCD read-out will return to normal when
the temperature inside the vehicle increases
to a normal range.
Volume Control
3
To increase the volume level, press the volume
+ button (3). To decrease the volume level,
press the volume down – button (3). The
volume will increase/decrease and the level will
be shown on the display panel from a minimum
of "VOL 0" to a maximum of "VOL 47". The
display will automatically return to the normal
indication 5 seconds after the last volume
adjustment or when another function is
activated. The volume control is also used in
conjunction with the SEL button (4) to adjust
the bass, treble, balance and fader levels.
1
MUTE
SRC
3
SEL
DISP
4
7
Bass Control
4
To adjust the bass level, first select the Bass
mode by pressing the SEL button (4) until
"BAS" appears on the display panel. Within five
seconds, press the volume +/– buttons (3) to
adjust the bass response from a minimum of
"BAS -7" to a maximum of "BAS 7". "BAS 0"
represents a flat response.
NOTE: You cannot adjust the Bass or Treble
options when the Preset Equalizer (DSP) is
activated.
2
UMP401 CD / MP3 / WMA / RECEIVER
ALBUM
MUSIC
ARTIST
INTRO
REPEAT
RANDOM
1
2
3
4
5
AS/PS
BAND
6
ST/MO
LO/DX
LOUD