Power Supply; Specifications & Technical Data - CABASSE SANTORIN IW Notice D'installation

e n g l i s h
Interconnections with the speaker terminals
Connections to the HI LEVEL INPUT5 plugs
If the preamp section of your Hi-Fi or audio-video system is
not fitted with a low level output, you should then connect the
AMR150 by using its loudspeaker terminals. When connecting
the L (left) and R (right) speaker outputs of your amplifier to the
HI LEVEL INPUT5 plugs of the AMR150, be careful not to cross
(-) and (+) cord of either L (left) or R (right) channel. Such a
phase inversion might damage your main amplifier.
Connections from the HI LEVEL OUTPUT4 plugs
These outputs can be used to bring the signal to the main louds-
peaker systems
Amplifier-subwoofer connections
Connect the speaker cable to the outputs
to the terminals of the subwoofer. Respect the phase and tighten
the bolts of the terminals firmly. Double check the correct tighte-
ning of the subwoofer bolts before they can no longer be easily
reached.

POWER SUPPLY

The AC IN3 cord must be connected to the mains to supply the
subwoofer. The selection of the right voltage 115 V - 230 V is
done with the selector 115 V - 230 V2. Switch POWER1, on
AUTO or ON. With the switch on the AUTO position, the unit will
mute after a few minutes without input signal. The system turns
on automatically when signal comes back.
Attention, before operating the unit, be sure that the operating
voltage of your unit is identical with that of your local power vol-
tage.
ADJUSTMENTS
LEVEL 0
For a first volume adjustment, position the CROSSOVER FRE-
QUENCY9 at around 180 Hz, and turn slowly the volume LE-
VEL0 clockwise from minimum level up to a position where you
feel that the subwoofer sound level is appropriate. A check of the
level adjustment will be necessary after following steps.
CROSSOVER FREQUENCY 9
This potentiometer adjusts the cut-off frequency which deter-
mines the working bandwidth of the subwoofer. This adjustment
should be done according to the specifications of the main spea-
kers and the room acoustics. Choose the best frequency after
various listening tests.
PHASE -
For a better sound integration of the subwoofer in the main sys-
tem, the PHASE- of the subwoofer might have to be inverted
(180° position), depending on the distance between the subwoo-
fer and the main speakers. You have to check the PHASE- each
time you move your speakers and each time you adjust the CROS-
SOVER FREQUENCY9.
Attention, if you use 2 subwoofers, both phase switches must be
on the same position.
8
of the amplifier and
WEEE MARK
Disposal of Wastes of Electrical & Elec-
tronic Equipment (Applicable in the
European Union)
This symbol on the product, consisting of the crossed-out wheeled bin,
indicates that this product shall not be treated as household waste. Ins-
tead it shall be handed over to the applicable collection point for the
disposal of electrical and electronic equipment at the end of life.
By ensuring this product is disposed of correctly, you will help pre-
vent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste han-
dling of this product. The recycling of materials will help to preserve
natural resources. For more detailed information about recycling of this
product, please contact your local city office, your household waste dis-
posal service or the shop where you purchased the product.
SPECIFICATIONS & TECHNICAL DATA
SANTORIN IW
In-wall subwoofer
Drive unit : 2 x 17S20 IW 17 cm (7 in) woofers
Frequency bandwidth : 35-175 Hz in semi-reverberating chamber
Maximum RMS SPL : 108 dB RMS
Dimensions (h x w x d) :
in wall : 108 x 36 x 9.5 cm / 42.5 x 14.2 x 3.7 in
on wall : 42 x 37 x 1 cm / 16.5 x 14.6 x 0.4 in
Weight : 16 kg / 35 lbs
AMR 150
Subwoofer amplifier
Maximum output power : 150 W
Peak power : 300 W
Lowpass cut-off frequency : 40 to 180 Hz
Phase switch : 0° normal - 180° phase reverse
Voltage : 110-120V/220-240V~ 60/50Hz
Maximum power consumption : 200W
Stanby power consumption :
0.45W @ 220-240VAC --- 0.45W @ 110-120VAC
Power consumption when off :
0.01W @ 220-240VAC --- 0.01W @ 110-120VAC
Useable temperature range : 5°C to +35°C
Storage temperature range : -5°C to +40°C
Useable humidity range : 40% to 70%
Dimensions (h x w x d) :
hi-fi layout : 88 x 427 x 335 mm /3.47 x 16.81 x 13.19 in
rack layout: 88 x 483 x 335 mm / 3.47 x 19 x 13.19 in
Weight : 9 kg / 20 lbs
Because of technical improvements already under way in our
constant search for optimum quality, Cabasse reserves the right
to modify all the models presented in specification sheets, advertising
materials and manuals without prior notice.
Our web site www.cabasse.com will give you the specific adjustments
we recommend for the use of our active subwoofers.