Pre-Start Inspection Procedures - Mi-T-M Corporation CD-1002-0MUH/UC Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

installation & preparation

pre-start inspection procedures:

Before starting the unit, perform the following procedures:
1. Check the oil level in the pump.
2. Inspect the inlet water strainer. Clean or replace if necessary.
"Water Supply", #2, pg. 11.
3. Check all hose connections to ensure they are securely tightened. See
"Water Supply", #3, pg. 11.
4. Inspect for system water leaks and oil leaks. Be sure that all damaged
parts are replaced and that the mechanical problems are corrected prior to
operation of the unit. If service is needed, contact Customer Service.
5. Inspect high pressure hose for kinking, cuts or leaks. If a cut or leak is
found, DO NOT USE HOSE! Replace hose before starting unit. See
"Miscellaneous Safety Precautions" #6, pg. 6. Be sure that all damaged
parts are replaced and that the mechanical problems are corrected prior to
operation of the unit. If you need service, contact Customer Service.
6. Inspect electrical cord for cuts. If a cut is found, DO NOT TOUCH OR
USE ELECTRICAL CORD! Replace cord before starting the unit.
tHe following pages contain operating and maintenance
instructions.
do not attempt to operate tHis pressure wasHer until you
HaVe read and understood all safety precautions and
instructions listed in tHis manual.
incorrect operation of tHis unit can cause serious inJury!!
do not alter or modify tHis eQuipment in any manner!
Mi-T-M CD-1002/1502-0MUH/UC Operator's Manual
warning
See
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cd-1502-0muh/uc

Table des Matières