Datamars Unigizer 15000i Mode D'emploi page 5

Parts of the energizer
Installation
Read all of the safety instructions in this manual and any
relevant government, regional and local safety standards
before installing the energizer.
Selecting a site for the installation
Follow these guidelines when selecting a site for your
installation.
Select a site where:
a good earth can be obtained
•
the energizer earth system will be at least 10 m (33')
•
from other earth systems (e.g. telephone, mains power
or the earth system of another energizer)
children and animals cannot interfere with the
•
installation
Make sure the energizer is installed:
adjacent to the electric fence
•
preferably in the middle of the electric fence system
•
close to a mains/line power outlet (if using a mains/line
•
supply to power the energizer)
at least 1 m (3') away from and not directly above the
•
battery (if using a battery to power the energizer)
If your installation is outdoors, also make sure that it is:
on firm ground away from flooding
•
inside a protective fence, if required.
•
Using the power adaptor and
battery leads
The energizer is supplied with a power adaptor (for
connection to mains/line power) and a set of battery leads
(for connection to a battery). Before connecting a power
adaptor or battery leads, ensure the energizer's selector
switch is set to Off .
To use the power adaptor:
1 Connect the power adaptor to the Power input socket
on the rear of the energizer.
2 Connect the power adaptor to a suitable mains/line
power socket, ensuring there is 25 mm (1") of clear
space around the power adaptor.
To remove the power adaptor:
1 Disconnect the power adaptor from the mains/line
power.
2 Pull on the white connector to remove the power
adaptor plug from the Power input socket on the rear of
the energizer.
To use the battery leads:
1 Insert the battery lead into the Power input socket on
the rear of the energizer.
2 Connect the energizer to the battery using the battery
leads supplied. Attach the red clip to the positive (+)
terminal of the battery, and the black clip to its negative
(-) terminal.
Note:
If the energizer is to be used as part of a permanent
outdoor installation such as a solar installation, the battery
lead clips should be replaced by permanent battery
connectors.
5