General Features; Refrigerator Interior Shelves - Haier HSB03 Guide De L'utilisateur

English
Install Limitations
• Do not install your refrigerator in any location not properly insulated or heated e.g.
garage etc. Your refrigerator was not designed to operate in temperature settings
below 55˚ Fahrenheit.
• Select a suitable location for the refrigerator on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc
Door Alignment
(see fig. # 1)
1. Remove the top hinge cover by using a flathead
screwdriver. Place the head under the front edge
of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head
screw driver.
3. Adjust the door or put a spacer in between and
tighten the screws.
4. Replace the top hinge cover by aligning the rear
of the cover with the rear of the hinge. Press firmly
cover until it snaps in place.
on the front of the
REFRIGERATOR FEATURES & USE

General Features

Adjustable temperature dial:
Your refrigerator will automatically maintain the temperature level you select.
The temperature control dial has 7 settings plus off. 1 is the warmest. 7 is the
coldest. Turning the dial to OFF stops cooling in both the refrigeration and
freezer sections. At first, set the dial to 4 and allow 24 hours to pass before
adjusting the temperature to your needs.
(Note: If the refrigerator has been placed in a horizontal or tilted position for
any period of time wait 24 hours before plugging the unit in.)

Refrigerator Interior Shelves

To remove or replace a full-width slide-out shelf:
(see fig. # 2)
1. Gently tilt the shelf up and slide forward until the shelf has been completely
removed.
2. To replace the shelf, gently slide the shelf back.
3
fig. 2
fig. 1