Heating Mode - THOMSON THCLI123NER Manuel D'utilisation

5.3. COOLING mode:
When the cooling mode is selected, the indicator light will be in blue color.
The air is cooled and the hot air is exhausted to the outside through the exhaust tube.
Adjust the fan speed and air temperature to suit your desired comfort level.
In Cooling mode, the desired temperature can be set between 16 °C and 32 °C, using
the buttons « » or « », key or the remote control. If you press the « » or « », the
set temperature is displayed and can be adjusted. After 15 seconds, the display returns
to room temperature.
Note: In Cooling mode: the air exchange hoses must vent outside.
5.4. Dehumidify mode:
When Dehumidify mode is selected, the indicator lights yellow color. The air is
dehumidified as it passes through the unit, but not completely cooled. If the ambient
temperature is higher than 25 ° C, the fan speed can be adjusted. Otherwise, it is fixed to
"low". It is not necessary to connect the flexible exchange of hot air to the outside of the
room.
Continuous drainage is necessary.
It is possible to use the continuous drainage to drain water collected:
5.5. FAN mode:
When FAN mode is selected, the indicator lights green color.
Air flows into the room, without being cooled.
Note: In FAN mode, the device does not need to be ventilated.

5.6. Heating mode:

This unit is equipped with a heat pump. Heating mode can only work if the ambient
temperature is below 27 ° C.
Select Heating mode with the MODE button on the control panel or remote control.
the indicator lights red color.
GB-9