How To Use - Ayce MJ1402B Notice Originale

8. Assemble the spray unit
Assemble the spray head with the water bottle by screw cover.
Align the slot of the spray head and mop support, push the support along the slot,
when the clips are locked, the support is fixed.
Insert the mop support end into the elastic tape, fasten the other end by the nylon
tape.
Nylon clips tape
slot
clips

HOW TO USE

ATTENTION:
Before use, the appliance shall be fully charged.
Keep the rubber clean before cleaning. There is track on the window, if the some dust on
the rubber.
If the battery is not enough, it cut off by itself.
All the dust and water should not exceed the max line on the tank.
Nylon clip
1. Charge the appliance
Plug the charge on wall electrical outlet, insert the charge plug into the propersocket, the
indicator is on red. When the light turns into green, it is full charged, pull out the charger.
2. Use as a scraper:
Remove the spray head, fill full the bottle by cleaning water, make sure the spray nozzle is
on "spray" or "stream". Spray the water on the window, clean the window by the cleaning
mop.
58 59 GB
08/2015