Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Removing the filter unit from the tank
Use your finger to hold the rib of the filter, and drag the whole unit out. Then hole the
unit to turn the filter left direction to take out the filter from the support. Don't take the
filter from the tank directly while it is difficult to take out the filter support from the
tank without the filter.
4.
Assemble the turning connector with tank
Align the screw ring to the tank, then tighten the ring to the right clock direction.
5.
Assemble the tank unit with the main body
Align the rib and notch, turn the tank to the body, thenhear a "ka", the tank locked by
the latch hook. push down the turning connector.
Then you can turn the connector free to adjust the suction direction.
Rib and
notch
6.
Assemble the accessories
You can change the accessories easily. Choose one accessory to insert into the con-
nector directly. Just pull out and change another.
The scraper is used for window and plane surface, it is just used for liquid.
The soft crevice tool is used for corner situation, it is used for liquid and dust.
The small brush is use for sofa, bed, floor, curtain, etc, it is only used for dust.
7.
Assemble the extension tubes
There are tubes, one have a handle cover, and the other have a tube connector. Insert
the lock into the tube connector if you want the extension tube for more length.
Insert the end of the tube with lock into the body casing until the lock of the tube is
locked at the hole.
Don't use extension tube before it is locked well, there is risk for dropping the unit if
it is not locked.
Just press the tube lock under the shell and pull out, then you can depart the exten-
sion tubes.
Tube lock and hole
56
57
Tube lock and connector
08/2015
GB
Publicité
Table des Matières
