ALPATEC RCMB 21 Notice D'utilisation page 10

Notice RCMB 21:notice RC_20ET 10/10/12 11:32 Page 10
STARTING
Put 2 AAA batteries in the remote control.
Plug the appliance. Room temperature is displayed on LED screen (12) and LED (6) is on.
STARTING.
Each time a fonction is on, the relative LED lights on.
Press M/A (17) button, the appliance starts to fan.
POWER SETTING.
Press Fonction button (16) to select low power (1000W).
Low power indicator (8) lights.
Press again Fonction button (16) to select high power (2000W)
High power indicator (9) lights.
TEMPERATURE. (Only available with remote control)
Press "+" and "-" (14 or 13) button to set the desired temperature (from 10 to 49°C).
The selected temperature flashes a few second on the LED screen, then the room temperature is
displayed again.
If the room temperature is higher than the selected temperature, the appliance fans only.
If it is lower it will switch to low power (if gap is below 2°C) or high power (if gap is more than 2°C)
TIMER.
Use Min. (15) button to select the desired time (from 30 min to 7h30).
Product will stop when the selected time is done.
STOP.
Press (17) button to switch off the heater.
It will fan only for a while to cool down the product and then stop.
SAFETY.
This appliance is equipped with an automatic cut off when overheating.
10