Technical Specifications - Buffalo GL190 Mode D'emploi

UK
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline or your BUFFALO dealer.
Fault
The appliance is The unit is not switched on
not working
The Stop button not released
(GJ461)
Plug and lead are damaged
Fuse in the plug has blown
Power supply
The overload switch has activated See overload switch information in the
Safety Guard not closed
Appliance not in gear
Bowl not fully raised
Bowl will not fit Bowl pins or surrounding area
back in to place clogged with mix
The appliance is The mixing bowl is overloaded
overheating
The appliance has been operating
for too long
The appliance is Bowl or mixing attachment not
noisy correctly fitted
Worn bearings/damaged gears
Grease has dried up in the
gearbox
The mixing The belt has become loose
attachment fails to
rotate properly
Cannot select gear Gearing cogs misaligned

Technical Specifications

Model Voltage
GL190 220-240V 50Hz
GL191
220-240V 50Hz
GJ461 220-240V 50Hz
16
GL190-GL191_GJ461_ML_A5_v7_20180928.indb 16
Probable Cause
Check the unit is plugged in correctly and
switched on
Turn button clockwise to release
Call BUFFALO agent or qualified Technician
Replace the fuse
Check power supply
Operation section of this manual
Close Safety Guard fully
Put in gear
Ensure the Bowl lever is pushed back fully
Clean the appliance
Turn off the appliance and empty some of the
contents
Turn off the appliance and allow to cool down
for 30 minutes
Remove and refit bowl/mixing attachment
Call BUFFALO agent or qualified Technician
Call BUFFALO agent or qualified Technician
Call BUFFALO agent or qualified Technician
Turn Off appliance and manually turn the whisk
attachment slightly. Select the gear again.
Power Current
550W 1.8A
1100W 4.7A
1500W 6.5A
Solution
Dimensions Weight
H x W x D mm (kg)
610 x 395 x 395 36kg
794 x 555 x 558 64kg
1142 x 579 × 611 160kg
Bowl
Volume
10L
20L
30L
2018/9/28 16:02