Glass Break Detector - Busch-Jaeger Busch-Jalousiecontrol II 6411 U-101 Mode D'emploi

Glass break detector

When using a timer operating element, a separate signal,
is sent to the operating element - you will find further
information in the operating manual.
b. Connection
The connection can be made under voltage. Proceed as
described in section b of the chapter on "Brightness
sensor". The correct polarity of the twin stranded hook-up
wire must only be respected with the brightness sensor.
You will find further information on the function
and attachment in the operating manual of the
glass break detector.
The shutter cannot be moved upwards via
the brightness sensor, a timer signal or via
an extension during or after triggering of the
switching command. Once the shutter has
moved down, it can only be moved up-wards
again via the operating element of the
flushmounted insert concerned.
ENG 79