KENMORE ELITE 796.8107 Série Manuel D'utilisation Et D'entretien page 32

TROUBLESHOOTING GUIDE
BEFORE CALLING FOR SERVICE (continued)
Problem
Steam Features Not Work-
ing (continued)
The display shows:
"d90", "d95"
Possible Cause
Cannot see steam vapor at the
beginning of the cycle.
Odors are not completely removed at
the end of the STEAM REFRESH cycle.
The duct work is about 90%-95%
blocked. This error code will only
display for two hours.
House exhaust system is blocked.
Steam is released at different stages of the
cycle for each option. Steam cannot be seen,
but condensation may form on the inside of
the door when steam is being generated.
Some odors are difficult to remove. Fabrics
containing certain difficult odors or very
strong odors may not refresh well and should
be washed or dry cleaned instead.
Do not use the dryer until the exhaust system
has been cleaned and/or repaired. Using
the dryer with a severely restricted exhaust is
dangerous and could result in a fire or other
property damage.
Check the outside dryer vent while the dryer is
operating to make sure there is strong airflow.
If the exhaust system is extremely long, have it
repaired or rerouted.
Keep the area around the dryer clean and
free of clutter.
Check vent hood for damage or lint clogging.
Make sure the area around the vent hood is
clear.
32
Solutions