Cycle Options And Special Features; Wrinkle Guard; Control Lock - KENMORE ELITE 796.8107 Série Manuel D'utilisation Et D'entretien

HOW TO USE

CYCLE OPTIONS AND SPECIAL FEATURES

Your dryer features several additional cycle options and special features to meet your individual needs. For all steam
features, see the following pages.

WrInKLe GUArD

Selecting this option will tumble the clothes after
the cycle ends for a few seconds every few minutes
without heat. This option is active for 180 minutes after
the end of the cycle, or until the door is opened. This
helps prevent wrinkles if the clothes are not removed
immediately after the cycle has finished.

COntrOL LOCK

Use this option to disable the controls. The Control Lock
can be activated any time the dryer is ON. When the
controls are locked "CL" will display alternately with the
estimated time remaining. Once set, the Control Lock
must be turned off before the controls can be used.
Press and hold the WRINKLE GUARD button for 5
seconds to lock or unlock the controls.
MY CYCLe
My Cycle allows you to store a customized dry cycle for
future use. It allows you to save favorite temperature, dry
level, and other options for a cycle, and then recall them at
the touch of a button.
NOTE: Only one My Cycle can be saved at a time. Press
and hold the MY CYCLE button to overwrite any previ-
ously saved cycle.
To save a MY CYCLE:
1
Press the POWER button to turn on the dryer.
2
Turn the cycle selector knob to select the desired cycle.
Press the CYCLE MODIFIER button to change the desired setting.
3
4
Press the CYCLE OPTION button to add the desired options.
5 Press and hold the MY CYCLE button.
To recall a MY CYCLE:
1
Press the POWER button to turn on the dryer.
2 Press the MY CYCLE button. The stored settings will
be displayed.
3 Press the START/PAUSE button to start the cycle.
NOTE: My Cycle can be adjusted the same as any
other cycle. However, once any other button is pressed,
the LED will turn off, indicating that the settings are no
longer those of your saved cycle.
DAMP DrY SIGnAL
If you select the Damp Dry Signal option, the dryer will
emit a chime when the clothes are just short of completely
dry, in case you want to remove them for ironing or hang
drying.
To activate the Damp Dry Signal, press and hold the
WRINKLE GUARD button for approximately three seconds.
INSTALLING AND USING THE DRYING RACK
With the dryer door open, slide the rack into the
1
dryer drum.
2 Make sure the front of the rack is seated properly in
the recess on the lint filter housing at the front of the
drum. The two rear legs of the rack should be resting
on the rear wall just above the drum.
3
Place items to be dried on the rack. Make sure that
no parts of the items hang over the edges of the
rack, as they might be contacted by the rotating
drum, causing noise or damage to the drum
or items.
NOTE: Be sure to remove the drying rack after using
the Rack Dry cycle.
To use the RACK DRY cycle:
Use Rack Dry with items, such as wool sweaters, silk, and
lingerie, that should dry flat. Rack Dry can also be used
with items that should not be tumbled dry, such as gym
shoes or stuffed animals.
1
Turn the cycle selector knob to select the RACK DRY
cycle.
2
Press the TEMP button to select from Low or Mid Low
temperature options. If no temperature is selected,
the cycle defaults to no heat
24
.