Noise Development; Technical Data; Disposal - CTC CLATRONIC BSR 1282 Mode D'emploi

Робот - пылесос CLATRONIC BSR 1282
Купить в интернет-магазине http://clatronic-shop.com.ua
Problem
The appliance does not work.
The battery is not charged. The
green status indicator does not
flash.
The battery is not being charged.
The green status indicator
flashes.
Insufficient suction power.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 70 dB(A) (no limit)

Technical Data

Model: ...........................................................................BSR 1282
Net weight: .........................................................................1.85 kg
Power Adaptor
Protection class: .......................................................................... II
Input: ......................................................AC 220-240 V, 50/60 Hz
Output: ........................................................... DC 16.8 V, 300 mA
Polarity: ........................................................................
Batteries: .......................................................12 x 1.2 V, 800 mAh
Operating time: ...................................................max. 30 minutes
Charging time: ...................................................................6 hours
Subject to technical changes without prior notice!
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.

Disposal

Remove Batteries / Battery Disposal
This device contains rechargeable Ni-MH batteries.
Remove the batteries before disposing of the device.
You are bound by law to return used batteries.
Troubleshooting
Possible Cause
The battery is not properly connected.
The battery is not charged.
The appliance is not properly connected
to the adaptor and/or the adaptor is not
properly connected to a mains power
supply.
Wall outlet is defective.
Adaptor is defective.
Appliance is defective.
Nozzle is blocked.
Dust container is full.
Filter is dirty.
Floor cloth is dirty.
Solution
Connect the battery properly (see chapter "Start-up").
Charge the battery (see chapter "Start-up").
Connect the adaptor properly to the appliance and
the wall outlet.
Try a different wall outlet.
Check your fuses.
Contact customer service.
Contact customer service.
Clean the nozzle.
Empty the dust container.
Clean the filter.
Clean or replace the floor cloth.
WARNING
• Disconnect from mains power supply before removing
the batteries!
• Remove the batteries only in discharged condition.
• Open the battery compartment: Press the lid slightly down
and open.
• Remove the adaptor cable plug from the jack in the battery
compartment.
• Remove the battery pack.
Return the battery pack at a collection point for exhausted bat-
teries. Enquire at your municipal offices for further information.
Meaning of the "Dustbin" Symbol
Protect our environment: do not dispose of electrical equipment
in the domestic waste.
Please return any electrical equipment that you will no longer
use to the collection points provided for their disposal.
This helps avoid the potential effects of incorrect disposal on
the environment and human health.
This will contribute to the recycling and other forms of reutiliza-
tion of electrical and electronic equipment.
Information concerning where the equipment can be disposed
of can be obtained from your local authority.
33