Franklin Electric Little GIANT SPW10 Mode D'emploi

Franklin Electric Co., Inc.
E N G L I S H
Oklahoma City, OK 73157-2010
www.lg-outdoor.com
customerservice@lgpc.com
EN
This instruction sheet provides you with the information required to
safely own and operate your product. Retain these instructions for
future reference.
The product you have purchased is of the highest quality
workmanship and material, and has been engineered to give you
long and reliable service. This product has been carefully tested,
inspected, and packaged to ensure safe delivery and operation.
Please examine your item(s) carefully to ensure that no damage
occurred during shipment. If damage has occurred, please contact
the place of purchase. They will assist you in replacement or repair,
if required.
READ THESE INSTRUCTIONS
ATTEMPTING TO INSTALL,
YOUR PRODUCT. KNOW THE PRODUCT'S APPLICATION,
LIMITATIONS, AND POTENTIAL HAZARDS. PROTECT YOURSELF
AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD
RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
Fitting
Raccord
Conexión
SPILLWAY
DÉVERSOIR
VERTEDERO
MODELS SPW10 and SPW18
MODèLES SPW10 et SPW18
MODELOS SPW10 y SPW18
ENGLISH
CAREFULLY
OPERATE, OR
Grommet/flange
Œillet/bride
Anillo aislante/brida
Fitting
Raccord
Conexión
Fitting
Raccord
Conexión
Refer to Figure 1 and the following steps to install your spillway:
1. Insert the grommet into the back of the spillway from the
outside, with the smaller flange inserted into the hole.
2. Select the proper fitting for your spillway.
3. Lubricate the outside of the fitting's non-threaded side with
liquid detergent.
4. Push the fitting through the grommet from the outside of the
spillway until approximately 1/4" to 3/8" of the fitting is visible
on the inside of the spillway. The friction of the sealing grommet
holds the pipe tightly in place.
5. Insert the filter media between the ribs in the spillway.
BEFORE
6. Determine the height of the spillway, then camouflage the
SERVICE
spillway using natural stone and earth. NOTE: Using a pump
that exceeds the recommended size can cause the filter media
to rise. If this occurs, place a cover of lightweight material over
the top of the spillway.
Filter media
Média filtrant
Filtro
FIGURE 1
INSTALLATION
1