Power; Speaker Connections; Tv As The Center Speaker; Antenna Connections - Philips MX-955 Mode D'emploi

Power

The type plate is located on the rear of the receiver.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
not, consult your dealer or service organization.
2 Connect the power cord to the power outlet.
To disconnect the unit from the power completely, remove the
power plug from the power outlet.

Speaker connections

Some of the speaker connections on the receiver are screw
connectors and some are click-fit connectors. Use them as
shown below.
1
1
1 Always connect the colored (or marked) wire to the colored
terminal and the black (or unmarked) wire to the black
terminal.
2 Connect:
– Left front speaker to L (red and black)
– Right front speaker to R (red and black)
– Center speaker to CENTER (blue and black)
– Left surround speaker to SURROUND L (grey and black)
– Right surround speaker to SURROUND R (grey and black)

TV as the center speaker

You may use your Philips TV with CINEMA LINK as the center
speaker. For TV's with cinch connectors, additional cinch
cables are needed. These cables must be connected to the
blue CENTER PRE-OUT connector on the back. Look into the
instruction manual of your TV on how to use it as the center
speaker.

Antenna connections

AM (MW) antenna
The loop antenna supplied is for indoor use only. Position the
antenna as far away as possible from the receiver, a TV, the
cables, a DVD player, a VCR and other radiation sources.
1 Fit the plug of the frame antenna to AM LOOP as shown below.
2 Turn the antenna for optimum reception.
FM antenna
The wire antenna supplied can be used only to receive nearby
stations. For better reception we recommend using a cable
antenna system or an outdoor antenna.
1 Open the FM 300 Ω click-fits by pushing the lever down as
2 3
2 Insert each wire of the antenna into one hole.
3 Close the click-fits using the lever.
2
3
4 Move the antenna in different positions for optimum reception.

FRONT AV / GAME cap (FR 975 only)

• To remove the FRONT AV / GAME cap, press on the right
• Insert the cap from below to close the compartment.
The unit complies with the FCC-Rules, Part 15.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
A
A N T E N N
P
A M L O O
shown below.
1
side of the cap.
including interference that may cause undesired
operation.
CONNECTIONS
2 3
13