Samsung NX60T8751SS Manuel D'utilisation page 47

Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
L C
1
2
3
8
7
6
NX60T8751SS_AA_DG68-01219A-00_EN.indd 47
1. Remove the center burner grate(C)
following both sides grates.(L/R)
2. Remove the burner caps from the burner
R
heads.
3. Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4. Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
5. Rinse and dry grates and burner
components thoroughly.
6. Return the burner heads to their
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.
NOTE
See the next page for detailed burner
component re-assembly instructions.
7. Return the burner caps to their positions
on top of the burner heads. To ensure
proper and safe operation, make sure the
burner caps lie flat on top of the burner
heads.
8. Reinstall the burner grates in their
respective positions.
9. Turn on each burner and check if it
operates properly. After verifying that a
burner operates normally, turn it off.
• The brass parts of your burner will change
• After cleaning, confirm that the burner
Brass burner head
• Do not wash any burner components in a
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
• The burner spreader can be blocked by food or dust. Clean the spreader if it
appears blocked. If you clean the spreader with water, assemble it only after it is
completely dry. If the spreader is wet, it might prevent the burners from igniting.
• To avoid falling down the grates, make sure to remove both sides grates first.
NOTE
color with use. However, this will not
affect performance and you can clean the
brass parts with a brass cleaner.
port openings aren't plugged.
dish washer.
English 47
3/26/2020 8:39:42 PM