Connecting Air Supply - Bosch CGT8-65W Consignes De Fonctionnement/Sécurité

CONNECTING AIR SuppLy

Firmly grasp the hose in hand
WARNING
when installing hoses. If hose is
not held firmly or correctly installed hose may whip
and injure personnel in the operating area.
InSTALLInG HOSES:
1. Grasp the hose at the quick connect plug and
push the plug into the quick connect body.
Coupler will snap into place.
2. Grasp the hose and pull to ensure coupler is
seated.
OpERATING TEMpERATuRES
Operating temperatures are between 32ºF and
104ºF (0ºC and 40ºC). If operating outside rec-
ommended temperatures, unit may have difficulty
starting and will cause additional wear on compo-
nents.
Disconnect
WARNING
from the power source, drain
air tanks and allow it to cool before making
adjustments, moving the compressor, leaving
Fig. 4
Fig. 5
the compressor
OPERATION
the work area, performing maintenance or
storing the compressor.
safety measures reduce the risk of injury.
ShuTTING DOWN ThE COMpRESSOR
1. Move the engine switch to the "off" position. (refer
to the Engine Manual accompanying this unit.)
2. Turn regulator until output pressure shows
0 psi,
3. Remove hose and hose assembly. See
"disconnecting air supply" below.
4. Drain air from the air tanks by releasing air by
pulling the safety release valve.
5. Once the air tank pressure is under 20 psi.,
open the drain valve on the control panel to
drain moisture from the tanks. See "Draining
Tanks" below.
6. Allow the compressor to cool down before
storing.
DISCONNECTING AIR SuppLy
DISCOnnECTInG HOSES:
1. Ensure regulated pressure gauge reads 0 psi (0
kPa).
2. Pull coupler on quick connect body back to release
quick connect plug on hose. (See figure 5)
1. Place the compressor on a level surface.
WARNING
not level, water will not drain from tanks causing
corrosion, which may cause the tanks to burst.
2. If pressure is greater than 20 psi, use safety
relief valve to reduce tank pressure.
3. Ensure that no personnel are in the drain
discharge area behind compressor.
WARNING
propel dust and debris at high speed. Compres-
sor air from the compressor can contain water,
oil, metal particles, or other contaminants which
can cause serious injury.
4. Turn drain valve on control panel 90°
counterclockwise.
WARNING
precautionary measures reduce the risk of injury.
5. When tanks are empty, close valve.
Such precautionary
DRAINING TANKS
ensure that the compressor is on
a level surface. If compressor is
Do not direct air stream at people
or animals. High pressure air can
Do open drain valve with pressure
greater than 20 psi in tanks. Such