Tool it PBT 700 Mode D'emploi page 19

Original manual
RECHARGE & RETEST
*Battery is discharged, the battery condition cannot be determined until it
is fully charged. Recharge & retest the battery.
BAD & REPLACE
*The battery will not hold a charge. It should be replaced immediately.
BAD CELL & REPLACE
*The battery has at least one cell short circuit. It should be replaced imme-
diately.
LOAD ERROR
*The tested battery is bigger than 2000CCA/SAE or 200AH. Or the clamps
are not connected properly. Please fully charge the battery and retest after
excluding both previous reasons. If reading is the same, the battery should
be replaced immediately.
SOC&SOHDisplay:PressdirectionalkeystoseeSOC&SOH:
GOOD & PASS
SOC: xx.xx V
90%
■■■■■■■■■
□
15. Press the keytoselectresultprinting:YESorNO.Press«ENTER»to
confirmyourchoice.
16. P ress«ENTER»returntoMAINMENUorremovethetestclampsfromthebatterypostsaftercomple-
tion of testing batteries to end test.
PBT 700 EN
RECHARGE & RETEST
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xxmΩ
BAD & REPLACE
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xxmΩ
BAD CELL & REPLACE
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xxmΩ
LOAD ERROR
GOOD & PASS
SOC: xx.xx CCA/SAE
90%
■■■■■■■■■
□
IMPRIMER LES RÉ-
SULTATS ?
OUI / NON
19